I kinked the fuel line by accident, and cut out the kink. I replaced it with gas hose and clamped it on each end. If I spray fluid in the carb the car will run as normal, but not on it's own. how do I reset the fuel safety shut off or pressure switch to make it run properly?
2006-07-26 16:05:49 · 4 answers · asked by maxgreenman 1 in Cars & Transportation ➔ Maintenance & Repairs
in the trunk,,you,ll find a panel on the side that comes off,,behind it is a relay unit,,with a button on it,,it will be in the up right position,mash it back sown until it stays,,this will reset it,,if it trips again then the unit may be going bad,,they do go bad after a few yrs,,but it may be OK,,drive the car after you get it started,,and make sure it is OK,,hope this help,s.
2006-07-26 16:11:41 · answer #1 · answered by dodge man 7 · 1⤊ 0⤋
If your car is a 190E it is fuel injected so how did you spray starter fluid in it? Since the pump is electric it works or does not work and if its not working how does the car get enough gas to run at all? Those cars do have a fuel pump relay located in the engine compartment. Good luck!
2006-07-26 23:20:22 · answer #2 · answered by uthockey32 6 · 0⤊ 0⤋
I would try and ask the guys at www.askautopro.com. You can email them and they get back to you free of charge with some guidance on how to fix your problem.
2006-07-26 23:09:25 · answer #3 · answered by Anonymous · 0⤊ 0⤋
its in the trunk under a panel that comes off
2006-07-27 00:12:30 · answer #4 · answered by Stephen M 2 · 0⤊ 0⤋