Hello! I just got Craftsm**'s 12' miter saw. When I pressed the trigger button, saw starts spinning but dies after 3~5 seconds. So I can only cut for 3~5 seconds at a time? Or is there a problem? I am using the recommend extension wire. Thanks!
2006-07-24 12:12:23 · 4 answers · asked by oskeewow13 3 in Home & Garden ➔ Do It Yourself (DIY)
you have a brush problem!! on the motor should be two round buttons with a slot in each,, un screw these and look at the brushes for signs of damage,, try to air blow any debris from the holes,, replace the brushes following the curve on the brushes and the contour of the armature,,try her again!! if no go,, then return\exchange
2006-07-24 16:28:59 · answer #1 · answered by fuzzykjun 7 · 0⤊ 0⤋
No, it is a lemon. Take it back to the store for an exchange or refund.
2006-07-24 19:16:08 · answer #2 · answered by webwench2005 3 · 0⤊ 0⤋
Not normal--no one would get any work done if it was. Take it back.
2006-07-25 15:36:05 · answer #3 · answered by M L 4 · 0⤊ 0⤋
AB-normal for sure
2006-07-24 22:31:04 · answer #4 · answered by ? 3 · 0⤊ 0⤋