2006-07-23 03:27:30 · 5 answers · asked by Anonymous in Cars & Transportation ➔ Other - Cars & Transportation
Yes,
Under the handle bars is a "neck" that goes into the frame. Right where the neck goes into the frame there is a threaded nut that can be loosened by turning it COUNTER CLOCKWISE. This will loosen the grip on the neck then you can raise or lower the handle bars/neck. Once you reach the correct height, tighten the nut by turning it clockwise. Good luck.
2006-07-23 03:42:56 · answer #1 · answered by Michigan 1 · 0⤊ 0⤋
You can get handlebar risers from most m/c shops which attach to the top of the current triple clamps. I think it would be pointless with clip on bars because sports bikes are designed to have very rigid and direct control of the steering head. I assumed you were referring to motorcycle bars.
Dirt bike bars can usually be rotated inside the triple clamp after loosening the triple clamp bolts. Otherwise just buy new bars with a higher profile and swap over the controls to the new bars.
2006-07-23 03:46:59 · answer #2 · answered by Neil S 4 · 0⤊ 0⤋
yes there is a nut at top near goose neck loosen it pull up on hand bars and ajust
2006-07-23 03:34:11 · answer #3 · answered by duckky44 3 · 0⤊ 0⤋
the law in most states the highest part of the handlebar can't be above your shoulders hope this is the answer your looking for
2006-07-23 04:00:52 · answer #4 · answered by Bob C 2 · 0⤊ 0⤋
for most bikes
2006-07-23 03:31:38 · answer #5 · answered by brdbeyondBelief 2 · 0⤊ 0⤋