Go to a gun store and get some G-96 or Wally world and get PB penetrant.
2006-07-22 05:53:24
·
answer #1
·
answered by jeff s 5
·
0⤊
1⤋
not impossible...find the right size socket, there's a lock on the drive shaft where you have to put a pin in there to immobilize the rotor assembly, apply a little wd-40 to the nut, and then try it in 10 minutes...some of those also turn the opposite way, so look carefully at the threads. Do you have the instruction book that came with it? If not, get a replacement booklet...
2006-07-22 12:53:55
·
answer #2
·
answered by gokart121 6
·
0⤊
0⤋
Try to soak with penetrating oil first and then attempt removal. If that doesn't work you can attempt heating the nut with a torch before removal. The key is to heat the nut without getting everything else too hot. The diameter of the nut will increase with heat making it easier to remove. Good luck !
2006-07-22 12:56:23
·
answer #3
·
answered by turbietech 4
·
0⤊
0⤋
put some oil on it or something, I don't know. or you can take a really long wrenchy thing and jump on it! that would be so cool! or put the wrenchy thing on the nut and bang in with a hammer on the end of the handle, I'v seen that work before.
2006-07-22 12:54:14
·
answer #4
·
answered by Jackie 2
·
0⤊
0⤋
That G-96 is some great stuff but penetrating oil has citric acid in it and will dissolve the rust.
2006-07-22 12:57:32
·
answer #5
·
answered by n317537 4
·
0⤊
0⤋
WD-40
2006-07-22 14:43:35
·
answer #6
·
answered by Anonymous
·
0⤊
0⤋
Try turning it the opposite direction sometimes they tighten left and loosen right. hope it helps.
2006-07-22 12:54:43
·
answer #7
·
answered by RM802001 2
·
0⤊
0⤋
Take it to the garage and have them use an air impact gun on this..
2006-07-22 13:42:21
·
answer #8
·
answered by Vulcan 1 5
·
0⤊
0⤋
It's reverse threads.
Turn it backwards.
2006-07-22 13:03:47
·
answer #9
·
answered by Mr. KnowItAll 7
·
0⤊
0⤋