i have a 2001 Yamaha big bear which has no spark at the plug.Has new cdi, new stator and pickup coil, ignition coil was checked on another atv and is working.Any ideas would help
2006-07-10 23:58:59 · 5 answers · asked by mad659 1 in Cars & Transportation ➔ Maintenance & Repairs
All answers were good but still no spark, have gone thru all the wiring twice and checked for good ground, still no spark
2006-07-18 12:49:00 · update #1
try the lead where it goes into the coil and also the HT lead, mine was shorting on to the frame
2006-07-11 00:18:14 · answer #1 · answered by Nimbus 5 · 0⤊ 0⤋
Dont know about this bike but seen a car with a Lambada sensor failed , on inlet manifold , same symptoms . Also would try to clean or change the brushes on the starter motor , also lead from battery to starter and smaller wire from starter to ignition switch. I would clean all earth points onto engine and chassis anyway
2006-07-17 23:09:48 · answer #2 · answered by Paul Sabre 4 · 0⤊ 0⤋
After checking the spark plugs did you see if it had GAS?
2006-07-11 07:02:37 · answer #3 · answered by mxamy 3 · 0⤊ 0⤋
check the plug lead, the plug cap and where it fits in the coil.
also try a new plug.
2006-07-11 09:24:29 · answer #4 · answered by XT rider 7 · 0⤊ 0⤋
Check to see if it is grounded.
2006-07-12 15:22:22 · answer #5 · answered by Anonymous · 0⤊ 0⤋