How do i change the fuel filter in a 98 buick regal?

Answer 1

here ya go


Removal Procedure

NOTICE: Cap the fittings and plug the holes when servicing the fuel system in order to prevent dirt and other contaminants from entering the open pipes and passages.

IMPORTANT: Always maintain cleanliness when servicing fuel system components.

IMPORTANT: There is no service interval for in-pipe fuel filter replacement. Only replace the in-pipe fuel filter if it is restricted.

1. Relieve the fuel system pressure. Refer to Fuel Pressure Release Procedure.
2. If plastic collar quick connect fittings are used, Refer to Quick Connect Fitting(s) Service (Plastic Collar) for the correct service procedure.
3. Raise the vehicle.
4. Remove the quick-connect fitting at the inlet of the in-pipe fuel filter. Refer to Quick Connect Fitting(s) Service (Metal Collar).
5. Remove the threaded fitting at the outlet of the in-pipe fuel filter.
6. Drain any remaining fuel into an approved gasoline container.



7. Remove the in-pipe fuel filter and mounting bracket.
8. Remove the in-pipe fuel filter from the in-pipe fuel filter mounting bracket.

Installation Procedure

NOTICE: Always re-attach the fuel lines and fuel filter with all original type fasteners and hardware. Do not repair sections of fuel pipes.

1. Remove the protective caps from the new in-pipe fuel filter.
2. Slide the in-pipe fuel filter into the in-pipe fuel filter mounting bracket.
3. Install the in-pipe fuel filter and mounting bracket.
4. Install the in-pipe fuel filter mounting bracket retaining bolt. Tighten Tighten the in-pipe fuel filter mounting bracket bolt to 20 Nm (15 lb. ft.). NOTICE: Refer to Fastener Notice in Service Precautions.
5. Install the quick-connect fitting at the inlet of the in-pipe fuel filter. Refer to Quick Connect Fitting(s) Service (Metal Collar).
6. Install the threaded fitting at the outlet of the in-pipe fuel filter. Tighten Use a back-up wrench in order to prevent the in-pipe fuel filter from turning. Tighten the in-pipe fuel filter outlet nut to 30 Nm (22 lb. ft.).
7. Lower the vehicle.
8. Tighten the fuel tank filler pipe cap.
9. Install the negative battery cable.
10. Inspect for leaks.

10.1. Inspect turn the ignition switch to the ON position for two seconds.
10.2. Turn the ignition switch to the OFF for ten seconds.
10.3. Turn the ignition switch to the ON position again.
10.4. Visually Inspect the fuel system for fuel leaks.

Answer 2

what's the question ? we ought to understand if there became some thing specific love that's a good thought to do this each 2 years or so. And for what its well worth in case you employ a good grade of gas like chevron with techron or Costco gas you are able to help shop the gas injection on your vehicle lots purifier. This ends up in much less problems from crappy gas which could clog up gentle gas injection sensors that the pc needs to run the par good.