Do I need to have an electrician come in to add GFCI protection to outlets or is something you can do yourself

Question

We recently sold our home and the inspection report came up with three outlets that are not GFCI protected. We're looking for a cost effecient way to take care of it.

Answer 1

You can do it --- just make sure to turn off the breaker to those outlets while you are doing it.

I searched "installing GFCI" and several sites popped up with instructions -- here's one of them

www.easy2diy.com/cm/easy/diy_ht_index.asp?page_id=35720244

Good luck and hey, turn off the breaker !!!

Answer 2

You can add the GFCI receptacles yourselves. This, of course, depends on your local building codes. Most states allow the homeowners to do the electrical repairs yourself. However, I highly recommend checking with your local building codes department.

Go to Home Depot or Lowe's and get the GFCI receptacles and an electrical tester if you don't have one. I prefer multimeters, but you atleast need something that measures voltage and a GFCI plug tester.

Go home and turn off the power to the circuits you are going to work on. Verify that the power is off before beginning any work.
Remove the receptacles that you need to replace and install the GFCI's.

The GFCI has a "line" side and a "load" side. The line side is the incoming power to that receptacle. The load side is the outgoing power to other outlets further down the circuit. Proper placement of the GFCI is critical to protect downstream devices.

The bare copper wire terminates to the green ground screw on the GFCI. The white wire terminates to the silver colored screws and the black wire terminates to the brass colored screws.

If you need further assistance, please visit -
http://electricalblog.gilchrist-electric.com

Answer 3

once you've a GFCI breaker on the circuit then you don't want a GFCI outlet. The GFCI breaker will look after the total circuit. A GFCI outlet is many times utilized in older properties that weren't initially stressed to contemporary codes. in case you study the instructions to a GFCI outlet it tells you that you'll be able to feed added customary outlet by potential of the GFCI outlet. on the decrease back of the GFCI outlet there are 2 instruments of screws one categorized line ( potential in) and yet another set categorized load ( potential out). There a a number of cyber web web pages that designate ordinary wiring consisting of three way switches and GFCI's and stuff. do exactly a glance for for "wiring a GFCI outlet". desire this facilitates.

Answer 4

Not hard to do. If you can follow instructions and know how to turn the power off, you could do it. All you need to do is watch how you take the old outlet out and put the new one in the same way. which the instructions should tell you too. If in doubt get someone that knows how to do it but beware of friends that say they know and really don't.

Answer 5

For three outlets I would just have an electrician do it. Part of an afternoon's and maybe a couple hundred bucks if they have to run the wires.

Answer 6

Hire an electrician, that is the cheapest safest way. If you are interested, this website tells you how to do it:

http://www.cornerhardware.com/howto/ht067.html

Answer 7

you can replace them. read directions in the gfci box.not that complicated

Answer 8

You can do it yourself just wire it the same way as the old one.

Answer 9

I would get an electrician to do it. You know it will be done correctly.

Answer 10

you can do them yourself unless you don't feel comfortable in doing it