1995 OLds Aurora. Only 1 side of the car has working vents in the front. The passenger side vents blow fine, and the rear vents work, but not the front drivers side. Any input / suggestions as to where to start. Can it be repaired by a regular old joe with some mechanical knowledge and no special tools, or is this a repair best left to the pros?
2006-06-27 13:29:36 · 4 answers · asked by Anonymous in Cars & Transportation ➔ Maintenance & Repairs
Check with your local library and see if they can get the Chilton manual for your car. If you look through it and see how the vents work, you may feel the job is one you can handle. If it looks too complicated, then it's off to the mechanic's shop.
2006-06-27 13:36:36 · answer #1 · answered by rakuchild_shines 2 · 0⤊ 0⤋
Look under your dash you should see a plastic hose that runs from the heat excahger to the vent on the driver side make sure it hooked up that's probably what is wrong with it.
2006-06-27 21:11:00 · answer #2 · answered by dl200558 5 · 0⤊ 0⤋
probably vent tube off look under dash for missing tubing chances are it got kicked offf if u go to a junk yard and compair to simularcar will be easiest if piece not missing something in tubes it is extremaly simple to repair you will need a screwdriver or a socket set to remove and a few miunets will be good as new
2006-06-27 20:39:28 · answer #3 · answered by hemi 1 · 0⤊ 0⤋
Just check the deflection plate under the drivers side...it might be hanging down....stick and pin the plate back up for proper air adjustment.
Good Luck
2006-06-27 20:36:21 · answer #4 · answered by WyattEarp 7 · 0⤊ 0⤋