English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

7 answers

Take it back to the dealer. It should be covered under warranty

2006-06-25 23:33:41 · answer #1 · answered by ilovemyarmyguy 3 · 1 0

The 'ninety 5 Chevy vehicles might want to nevertheless have the older style of twist in bulb receptacles. look into all of your turn signal receptacles for scoring or melting on the component to the truck that's having complications. If any receptacle would not look in good structure then replace it. in case your truck has the more recent type circuit board in the rear, then the technique is an same, yet you would ought to interchange the finished board if there's a difficulty. Your turn signal flasher is less than the sprint. it really is sq. plastic and sounds like a relay. The flasher must have 3 pins that connect to both the fuse panel, or into its own receptacle fixed above the fuse panel someplace. There are a minimum of two varieties of flasher that look the very same besides the undeniable fact that the pins are marked in yet otherwise, so in case you replace it with the incorrect one the turn signals gained't artwork. yet another probability is you would have a floor short in the wiring to that section. the in uncomplicated phrases different probability, different then demonic possession, is a difficulty in the turn signal swap itself. If each little thing else has been checked and repaired as necessary, then it must be the swap. to interchange it you need to get the change section, guidance wheel puller, and a lock plate remover. you need to take the guidance wheel off to interchange it.

2016-11-15 06:40:24 · answer #2 · answered by cozzens 4 · 0 0

One possibility is one of the flasher/turn signal bulbs is burned out and needs to be replaced. However, with an 06 model of any vehicle, that would be rare. Might be a loose bulb or bad connection. Other than that the dealer might have to look at it, take advantage of the warranty.

2006-06-25 23:35:08 · answer #3 · answered by vhtman 1 · 0 0

The indicator switch may be faulty. If that's the case that's why it still works on the 4 way flasher But hard to say without having a look!!

2006-06-25 23:34:26 · answer #4 · answered by honky550 3 · 0 0

IF the signal inside the vehicle is working but not outside, front or rear than it is a bulb, if none are working than it is either the sensor, fuse, or a problem with the actuator. Return to dealer for this issue because this is under warrenty.

2006-06-25 23:40:28 · answer #5 · answered by CrzyCowboy 4 · 0 0

Sounds like a burned out light bulb.

2006-06-25 23:34:58 · answer #6 · answered by regerugged 7 · 0 0

might have a bad ground connection. check for power with test light.inspect bulb.

2006-06-26 00:36:45 · answer #7 · answered by Anonymous · 0 0

fedest.com, questions and answers