2006-06-25 11:38:57 · 2 answers · asked by Anonymous in Cars & Transportation ➔ Maintenance & Repairs
Usually they are pressed into the hub.You can just pop them right out with a 2lb hammer and just wrench the new ones in with a stack of washers instead of the wheel as you could damage it. After about 50 miles or so you should re torque the lug nuts to ensure that all the studs are fully seated.
2006-06-25 11:47:16 · answer #1 · answered by Ricky J. 6 · 0⤊ 0⤋
from the back drill a hole in the center of the stud just smaller than the stud spray WD40 .than hit the stud from rim side the the hole cause a relieve so it come out easier. Put the stud in screw in the nut so the stud set in just so than put on your spare rim than tie it down the nut so you don't mess up your good rim .
2006-06-25 15:32:41 · answer #2 · answered by ssanchez2002 4 · 0⤊ 0⤋