I conected it without plugging enything in the device, later I pressed test botton, after that it was dead.....help please
2006-06-18 08:55:40 · 5 answers · asked by carlos thunder 2 in Computers & Internet ➔ Other - Computers
The UPS has an internal battery that is disconnected for shipping. Have you connected the battery inside? Did you get the polarity right? If the UPS is plugged into the wall and turned on, it should power any connected devices while it charges the battery, assuming that the wall plug is live. If this is a used UPS that you inherited, then the battery may need replacing. The battery has a finite cycle life. Check to see if the circuit breaker or fuse is reset and good.
2006-06-18 09:06:23 · answer #1 · answered by Hums2oldies 3 · 6⤊ 1⤋
The UPS is a battery and power conditioner. Check that the fuse to the UPS unit is ok and that you have it fully charged.
The test button you pressed may have been a test of an overload and it, correctly, disconnected the appliance. Have a look at the manual and see if it was and how you reset it.
2006-06-18 08:59:25 · answer #2 · answered by Anonymous · 0⤊ 0⤋
You usually have to charge it 24 to 48 hours first. Try that.
2006-06-18 08:58:12 · answer #3 · answered by Anonymous · 0⤊ 0⤋
Check the fuse?
2006-06-18 08:58:17 · answer #4 · answered by love_2b_curious 6 · 0⤊ 0⤋
get a enw one or try the troubleshooting thisng that ere in the user manual when u bought it.
2006-06-18 09:16:48 · answer #5 · answered by Yahoo! Answerer 6 · 0⤊ 0⤋