how to bleed the brake line on a 1997 nissan truck?

Question

can anyone tell me how to bleed the brake line on a 1997 nissan truck?

Answer 1

First make sure you keep the fluid full in the master cylinder at all times while you are bleeding them.Second,have a friend sit in the drivers seat and pump the brakes several times,hold the pedal down and starting at the passengers back wheel loosen the bleeder screw and count to three and tighten it and have the friend pump the brakes again and do the same to the other calipers,starting with the passengers back,then the drivers back,then the passengers front,and then the drivers front.Do this several times to each wheel to make sure you have the air all out.you will know because the pedal will fill tighter.

Answer 2

once you're doing a one guy or woman bleeder job with a hose in a Pepsi bottle containing a splash fluid earlier the bleed, make specific to tighten the bleeder screw earlier you get rid of the hose. in case you have anti-lock brakes, there may well be various of places you're able to desire to bleed the traces to boot on the wheels. you're able to have gave greater advice relating to the year and style of the truck. you're able to might desire to earnings a provider handbook. in case you do not have anti-lock brakes, you will purely might desire to bleed on the wheels. another one guy or woman bleeder techniques are velocity bleeder alternative bleeder screws, a objective means Bleeder, and a Mityvac. additionally in case you pump the pedal positioned an old e book or a quick piece of a 2x4 below the brake pedal (a block approximately an inch or 2 thick). An different technique is to easily open the valves one after the different (do the rear first so as of the gap from the grasp cylinder) and enable gravity do the bleed. It conceivable to open the different bleeder valves earlier the previous or first one is complete whilst you're doing an entire flush instead of basically a bleed. that would velocity up the job. it particularly is you are able to bleed all 4 traces on an identical time. it particularly is greater useful to apply the earlier descibed Pepsi bottles on the valves whilst gravity bleeding. once you're doing an entire flush take a turkey baster and get rid of a important sort of the fluid in the grasp cylinder and replace it with clean fluid. try this earlier the flush.

Answer 3

Just like the rest. You can do it the poor boy way and open the bleeders on the calipers and wheel cylinders (rear) and open the lid to the master cylinder and let the fluid push out the air while keeping the master full. Then run around and tighen them all up after a while. Otherwise, have a friend pump them up and then hold them on the floor and crack the bleeders one at a time to force the air out, tighten them before removing pressure from the pedal and pump them up again when you move to the next caliper or cylinder.

Answer 4

Well first of all there are brake lines, not just one. You need to bleed them all in any event that the brakes were worked on. If you are familiar with auto repair get an auto repair manual to do it yourself. Otherwise take it to a professional repair shop.