2006-06-14 09:25:16 · 4 answers · asked by cude84 1 in Cars & Transportation ➔ Maintenance & Repairs
For safety release fuel pressure first. Always wear safety goggles in case there is still pressure to protect your self. Also have some type of container to drain excess fuel into. If you jack vehicle up use safety stands and chuck wheals.
REMEMBER THERE IS ALWAYS TIME FOR SAFETY!!!
Check owners manual and remove fuel pump fuse and start car and wait until it dies. this will relieve the fuel pressure.
The Fuel filter has one clip and one threaded connector. Remove clip with your hand and remove line.
You will need a 20mm flare wrench and a 16 mm flare wrench. Put 20mm wrench on filter and 16mm on line remove line. The filter is held on by a 10mm bolt remove bolt and replace filter and reverse directions.
Put fuel pump fuse back in and cycle the ignition key three or four time to pressurize fuel line, Start vehicle and check for leaks.
2006-06-15 06:35:28 · answer #1 · answered by scoutaboutpack26 2 · 2⤊ 0⤋
You should find a spring clip atatched to one side and a fitting on the other. You need a wrench for the fitting and their are special wrenches "flare nut" that help keep from round off the nut .
2006-06-14 16:33:02 · answer #2 · answered by 007 3 · 0⤊ 0⤋
Step by step instructions with pictures can be found here:
http://www.autozone.com/servlet/UiBroker?ForwardPage=/az/cds/en_us/0900823d/80/09/ea/10/0900823d8009ea10.jsp
2006-06-14 16:32:13 · answer #3 · answered by hsueh001 5 · 0⤊ 0⤋
go to grandamgt.com and do a search under technical Q&A. you will get your answer in seconds.
2006-06-14 16:28:47 · answer #4 · answered by JimL 6 · 0⤊ 0⤋