can't read disk?

Question

when i start my computer, it says cannot read disk press alt, ctrl, del to restart. but everytime i do that the same thing happens. the thign is that i never opened up my computer for a while and that just happened a few days ago. what's wrong?

when i start my computer, it says cannot read disk press alt, ctrl, del to restart. but everytime i do that the same thing happens. the thign is that i never opened up my computer for a while and that just happened a few days ago. what's wrong?

yeah my sis put in a flash drive and it did that does that help?

yeah my sis put in a flash drive and it did that does that help?

Answer 1

there is clearly a problem with your hard drive - if you have a boot disk, you should try using it, and then checking if any of the C: drive is readable.

visit

www.ultimatebootcd.com

for some good boot utilities and advice...

Answer 2

My bet is, one of two things. If it says it can't read the disk then it probably sees it but the data somehow became corrupted. Contuining along these lines if your boot drive was not C: and was some other letter, Windows has a knack for changing it to C: on a whim and that misplaces all your boot files. Or, it's as simple as a loose cable. Check both the power and IDE cables. If none of that works then it's the drive, you may have to consider purchasing a new one and reinstalling.

Answer 3

Try to do the following:
1.check jumpers see if there on master.
2.check the BIOS boot sequence
3.Change the IDE cable
4.Check that IDE1 or IDE Controller is working
5.Try to Auto detect the Hard disk drive in the BIOS
6.If the problem persist try to Format and Install the Operating
system. But first Backup your hard disk drive by slaving your HDD
copy data to another drive.

Answer 4

Check the IDE cable and power connection to the hard drive...if you have this message it sees the drive but cannot read into it..not a good thing. Try restarting into safemode (F8 while booting up).

Good Luck!

Answer 5

check out the force: Cl initiate Settings administration Panel device Hardware gadget supervisor suitable-click on the force and choose properties you would be counseled no count if or no longer the force is working exact. ********************************* Are you utilising suitable disks? in case you decide directly to apply a CD as an information disk, you're able to desire to apply CD/RWs and the CD/RW might desire to first be formatted with the utility that powers your force (assuming you have a CD/RW force). in the journey that your force is CD/ROM, it is going to basically examine CDs. If it would not, the two the CD or the force is defective.

Answer 6

doe sit say which disk? can try going to safe mode by pressing F8 and then once in hit start run type chkdsk and see if there is any errors dont do anything other then that with the chkdsk though u dont want to use fa parameter send me email if still have issues

Answer 7

First u can try booting with ur boot disk as in floppy or cd.
Or press f8 whn systm Boot, thn try loging in safe mode
then on command prompt type c:/chkdisk

Answer 8

Check your hard disk data cable and power cable

Answer 9

man i hope u didn't get that new virus did u open any mail that had a Olympic torch in it did you? if u did u r screwd this virus is so deadly that Microsoft has no cure for it it comes in your email as a invitation

Answer 10

you have a vires try to boot in to sake mode and run a anti-vires ! if all els fails you will need to scrub the hard drive and reistall your op. sys.