2006-06-10 05:24:17 · 8 answers · asked by Anonymous in Home & Garden ➔ Maintenance & Repairs
yea pry hot water heater
2006-06-10 05:44:42 · answer #1 · answered by BECKER 5 · 0⤊ 0⤋
Sometimes under certain conditions, hot water can back up the cold water line. It doesn't go very far, but if the faucet is close enough, you can get hot water out of the cold tap. It wont last very long though. If you are continually getting hot water at the tap, try this. Turn on the cold and hot water taps. Let them run for a little bit. Get under the sink and feel the lines going up to the faucets. Follow them up and see where they are connected to the faucet. That will tell you if they are hooked up backwards. Good luck!!
2006-06-10 12:00:13 · answer #2 · answered by djjay_2000_00 3 · 0⤊ 0⤋
NO,, a messed up hot water heater can not mess with your cold water!! those other two answers just shows how stupid people are!! the cold water comes directly from your supply, the hot water branches off from the supply and goes into the heater and then by seperate lines goes to the hotwater taps,, someone connected the wrong line to your faucet!!!
2006-06-10 08:42:38 · answer #3 · answered by fuzzykjun 7 · 0⤊ 0⤋
the reset button is for while the over present day gadget gets heat or warm and journeys open, combating eletrons to pass, and while u push on that crimson button u are reconnecting the gadget, with the circuit so it may artwork back, now decrease back to the chilly water as what kerry mentioned later interior the solutions, turn off the potential getting into heater, turn off the water, drain unit. it may desire to take some doing toget the warmers out, there's a greater and a decrease u could desire to replace the two at present so as that they are paired at the same time the two new.I f seem on the warmth element u can see some markings as to what length it is 4000watts or 2500watts or what ever and in all hazard the voltage additionally or the ohms what the element is rated for u can take a ohm meter and have a look into the climate to work out in the event that they are undesirable even earlier u take it aside, if u positioned the ohm meter on continuity and positioned the leads on the screws black on one the crimson on the different whether it is undesirable it wont make a valid whether it is good it is going to. good success
2016-12-08 08:09:51 · answer #4 · answered by ? 4 · 0⤊ 0⤋
The hot water heater is not messing up.who ever hooked it up most likely messed up. Have someone check it out.
2006-06-10 05:30:59 · answer #5 · answered by toytazjojo 1 · 0⤊ 0⤋
Sounds like the cold and hot pipes are reversed.
2006-06-16 23:40:10 · answer #6 · answered by corvette 6 · 0⤊ 0⤋
have some 1 to fix it for u .
2006-06-10 05:30:09 · answer #7 · answered by alyamed 4 · 0⤊ 0⤋
I RAN INTO THAT PROBLEM ONCE .IT LEAD TO A BAD CARTRAGE IN THE SHOWER .IF YOU OWN A OLDER MOEN FAUCET .THAT MIGHT BE YOUR PROBLEM
2006-06-11 02:54:23 · answer #8 · answered by ata31254 3 · 0⤊ 0⤋