Kann ich unter Linux auch Sata Platten mit smartmon tools überwachen?

Question

Bei der Standardkonfiguration die bei Centos dabei ist scheint das nicht zu gehen, denn der msartd zeigt beim starten immer fehlgeschlagen an.

Answer 1

Können schon, aber wohl nur unter bestimmten Bedingungen;-)

Unter http://smartmontools.sourceforge.net/#testinghelp steht:

FireWire, USB, and SATA disks/systems

...
Smartmontools should work correctly with SATA drives under both Linux 2.4 and 2.6 kernels, if you use the standard IDE drivers in drivers/ide. If you use the new libata drivers, it won't work correctly because libata doesn't yet support the needed ATA-passthrough ioctl() calls. Jeff Garzik, the libata developer, says that this support will be added to libata in the future. When this happens, we'll add support to smartmontools for a new SATA/libata device type '-d sata'. Typically, to force an SATA disk to run using the standard (non-libata) drivers, you must use the BIOS to select "legacy mode" for the controller. If the IDE driver doesn't support your particular SATA controller, or the controller doesn't have a legacy interface, then only libata can be used. Unless the hard disk controller on the system motherboard is Intel, VIA or nVidia, standard IDE drivers may not work

Note: an unofficial patch to libata that allows smartmontools to be used with the standard '-d ata' device type was posted to the linux kernel mailing list at the end of August 2004. The patch is included in the libata-dev patchset that can be applied to a recent Linux kernel (>= 2.6.9). With a SATA disk driven by a libata driver, smartmontools can now be used by specifying both the device type 'ata' and the SCSI device corresponding to this disk, for example, smartctl -i -d ata /dev/sda. The patch is still under development and it is probably best to make sure that the disk is idle before trying smartmontools.

Answer 2

glaub nicht, dass das geht...